To use NAT in the platform, first configure the NSX integration, then define the NAT device. NAT networks are very similar to public networks.
To create a NAT network:
Click the + add button
Create networks with ranges of public IPs for NAT
The name of the NAT network
|Net. Address||The network address of the NAT network|
The network mask in CIDR format. For IPv4, the networks created in the platform the netmask can have a value from 16 to 30 inclusive, and for IPv6, it can have a value of 64, 56, or 48.
The NSX device that will manage the NAT network
To add IP addresses to your network, click the + Add button in the top right-hand corner of the Networks page.
When you add IPv6 addresses on strict networks, you don't need to set the starting address.
On non-strict IPv6 networks, Abiquo recommends that you create an automatic IP address, or you can enter an IP address manually as shown here.
The NAT network and IPs will display on the NAT tab. In the same way as for public IPs, you can quarantine NAT IPs as required
When users create virtual datacenters, the platform will automatically configure a NAT IP, and users can manage NAT rules, and purchase additional NAT IPs. See Manage NAT for virtual datacenters