When you edit a public network, you can change some or all of the following fields, depending on whether you have virtual machines deployed in the network or not.
The name of the public network
|Gateway||IPv4 only. The gateway of the network. Make sure the gateway is an IP address inside the range defined by the network address and the network mask|
The VLAN tag to use for this VLAN. Abiquo recommends that you check the tag for availability. Green: tag available. Yellow: tag already in use but can be shared. Red: tag excluded from use in the rack.
|Network service type||The Network Service Type, which represents a Network Interface on the hypervisors. Configure Network Service Types when you configure physical machines. Must be configured in the switch for use with VLANs. Cannot be changed when there are deployed VMs in the network|
|Device||The device pointing to the network virtualization system to use for SDN|
|Restricted||Mark this checkbox to restrict this network so that when editing VMs, only users with the privileges to Attach NICs in restricted networks and/or Detach NICs from restricted networks can work with IPs in these networks|
|Static routes||Select Define to edit static routes for the network|
You can modify these fields at any time but the changes will only apply to virtual machines deployed after the changes are made.
The address of the primary DNS server for your network
|Secondary DNS||The address of the secondary DNS server for your network|
The DNS suffix for your network