Abiquo Documentation Cookies Policy

Our Documentation website uses cookies to improve your experience. Please visit our Cookie Policy page for more information about cookies and how we use them.


Abiquo 4.6

Skip to end of metadata
Go to start of metadata




Configure NAT for datacenters

As part of the Abiquo NSX integration, you can use the NAT blueprint to configure virtual datacenters with NAT.

To configure NAT for a datacenter:

  1. Go to Infrastructure → Private → select datacenter → Servers view → Network → Devices
  2. To define the NSX integration in Abiquo, create a NAT device




Create a NAT network

To use NAT in the platform, first configure the NSX integration, then define the NAT device. NAT networks are very similar to public networks.

To create a NAT network: 

  1. Go to Infrastructure → Private → select datacenter → Servers view → Network → NAT
  2. Click the + add button

  3. Create networks with ranges of public IPs for NAT

    Field

    Value

    Network Name

    The name of the NAT network

    Net. AddressThe network address of the NAT network

    Netmask

    The network mask in CIDR format. For IPv4, the networks created in the platform the netmask can have a value from 16 to 30 inclusive, and for IPv6, it can have a value of 64, 56, or 48.

    Device

    The NSX device that will manage the NAT network

  4. To add IP addresses to your network, click the + Add button in the top right-hand corner of the Networks page.

    Enter the number of IPs and the first IP address in the range. The first IP address must be a new address that does not already exist in the network. After creating the first IP address, the platform will try to create the other IPs and it will skip any existing IP addresses. 

    For example, if you have IP addresses in network 30.30.30.30, which are 30, 33, and 34 and then you request 3 new IPs from 30.30.30.31. The new IPs created should be as follows: 31, 32, 35. 
    IP Addresses
    30.30.30.30
    30.30.30.31
    30.30.30.32
    30.30.30.33
    30.30.30.34
    30.30.30.35
     Click here to show/hide IPv6 details

    When you add IPv6 addresses on strict networks, you don't need to set the starting address.

    On non-strict IPv6 networks, Abiquo recommends that you create an automatic IP address, or you can enter an IP address manually as shown here.

The NAT network and IPs will display on the NAT tab. In the same way as for public IPs, you can quarantine NAT IPs as required

When users create virtual datacenters, the platform will automatically configure a NAT IP, and users can manage NAT rules, and purchase additional NAT IPs. See Manage NAT for virtual datacenters

API Documentation

For the Abiquo API documentation of this feature, see Abiquo API Resources and the page for this resource NatNetworksResource.